Running a Simulation

• Simulations are run by placing chips and wires on the 
				breadboard, and then turning the power on OR selecting
				'Begin Simulation' from the 'Clock' menu.  The power 
				toggle switch is located on the left side of the window 
				(between the +5 and GND terminals).  Wires can ONLY 
				be added/modified and chips can only be added/moved
				when the power switch is off.
• Use the demo circuit to experiment with the power switch, 
				placing and moving wires, moving chips etc.
• Move the 'B' input wire from the dip switch to the clock 
				input to experiment with the different kinds of clocking 
				options available in the 'Clock' menu.
•  Waveforms/Timing-Diagrams can be examined after 
				ending a simulation.
• Finally, don't miss the buzzer output!  It can be a very 
				handy feature.